51 32 170 Removing and installing/replacing front left or right door window glass (Security)

Necessary preliminary tasks:

IMPORTANT: The insides of the windows have a polycarbonate coating which must not be damaged or scratched.
Clean with antistatic plastic cleaner only.

Connect special tool 61 3 060 to plug connection (1) and special tool 61 2 071 .

IMPORTANT: Energize power window unit for max. 0.5 seconds in end position (risk of damage).
Energize special tool 61 2 071 with 12V, the door window opens or closes through polarity reversal.

Fig 1: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Open door window glass to gain access to screws (1).

Slacken bolts (1)

Tightening torque: see 2AZ in 51 32 FRONT DOOR WINDOWS

Version with window heating:

Disconnect plug connection for window heating lead (braided sleeve) on door side. Pay attention to routing for subsequent installation.

Installation:

If necessary, check ease of movement of window heating lead.

Fig 2: Identifying Door Window Glass Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Turn door window glass and lift out towards rear/top.

Installation:

Adjust door window glass.

Fig 3: Removing Door Window Glass

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

INITIALIZE power windows

Check function.

IMPORTANT: Power windows have no anti-trapping mechanism.
There is no "Close" one-touch function or "Close" comfort function in the Security version.