12 13 511 Replacing ignition coils

Necessary preliminary tasks:

Unlock plug retainer (1) of ignition coil (2) and disconnect plug.

Pull ignition coil (2) up and out.

This procedure is applicable to all ignition coils.

Fig 1: Unlocking Plug Retainer Of Ignition Coil

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check that rubber seal of ignition coil (1) is correctly seated.

Fig 2: Identifying Rubber Seal Of Ignition Coil

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Push plug (1) with plug retainer (2) open onto ignition coil.

Carefully close plug retainer (2) in direction of arrow.

The plug retainer must snap into place without great effort.

Fig 3: Pushing Plug With Plug Retainer

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Now clear the fault memory.