11 13 Oil Pan
OIL PAN - TIGHTENING TORQUES SPECIFICATION
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Oil drain plug | N54 | M12 x 1.5 | 25 Nm | |
| 2AZ Oil pan on engine block Aluminium oil sump Aluminium screws/bolts are marked with blue paint. |
N54 | M8 x 26 | Replace screws Thread repairs exclusively with Al Helicoil Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | |||
| Torque angle | 90° | |||
| 3AZ Oil pan on engine block Aluminium oil sump Aluminium screws/bolts are marked with blue paint. |
N54 | M8 x 92 M8 x 112 |
Replace screws Thread repairs exclusively with Al Helicoil Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | |||
| Torque angle | 180° | |||
| 5AZ Oil deflector to crankcase lower section Aluminium screws/bolts are marked with blue paint. |
N54 | M6 x 20 | Replace screws Thread repairs exclusively with Al Helicoil Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | |||
| Torque angle | 90° | |||
| 5AZ Oil drain plug | N54 | M12x1.5 | Replace screws | 25 Nm |