18 32 060 Removing and installing/replacing catalytic exhaust-gas converter for cylinders 4-6 (N54)
WARNING:
Scalding hazard!
Only perform these tasks after exhaust system has cooled down.
Only perform these tasks after exhaust system has cooled down.
Necessary preliminary tasks:
NOTE:
The oxygen sensors are in danger of being damaged when the exhaust manifolds are removed and installed.
Unfasten clip. In so doing, secure catalytic converter (1) against falling out.
Remove catalytic converter (1).
Installation:
Clean sealing face and replace seal.
Tightening torque 18 00 3AZ .