Dynamic Stability Control DSC 8: Operation
The DSC button is in the center console switch cluster (SZM)
The DSC button has 2 functions that can be set by pressing the button for different lengths of time.
DSC BUTTON FUNCTION CHART
| Press button | Function | Remarks |
|---|---|---|
| short < 3 seconds | DTC function activated. | DTC indicator light on. DSC indicator and warning light on. |
| long > 3 seconds | DSC is completely deactivated | DSC indicator and warning light on. This mode is intended for service work (e.g. brake dynamometer). |
NOTE:
Reactivating DSC
Briefly pressing the button again reactivates the DSC function. The DSC indicator and warning light goes out (unless the system has developed a fault).
If the DSC button remains pressed for longer than 10 seconds (e.g. by a handbag on the center console), DSC will detect an operating error. The DSC function remains active and cannot be deactivated until the ignition has been switched off and on again.
Briefly pressing the button again reactivates the DSC function. The DSC indicator and warning light goes out (unless the system has developed a fault).
If the DSC button remains pressed for longer than 10 seconds (e.g. by a handbag on the center console), DSC will detect an operating error. The DSC function remains active and cannot be deactivated until the ignition has been switched off and on again.