LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> X5 48i >> Repair and Diagnosis >> External Pages >> Different car >> Section 970 (Tire Pressure Monitor Systems) >> Dismounting/Mounting Procedures >> Tire Pressure Sensor >> Installation

Tire Pressure Sensor: Installation

WARNING: This page does not describe the selected car, but rather 37 other vehicles, including the 2010 BMW M6, 2010 BMW M5, 2010 BMW 650i, 2010 BMW 550i, and 2010 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
  1. Mount tire to wheel following tire changer manufacturer's instructions while paying special attention to the following to avoid damaging tire pressure sensor:
    • When the sensor is installed, the rim must not be cleaned with high-pressure cleaning equipment.
    • Visually inspect sensor for external damage and check for tight fit. DO NOT retighten screw and union nut. If one of the valve parts is loose, replace the entire valve.
    • Keep sensor free of tire mounting paste.
    • Fit lower tire bead so that no pressure forces are exerted on sensor.
    • Fit upper tire bead so that no pressure forces are exerted on sensor.
  2. Install tire/wheel assembly on vehicle. Reintialize TPM system. See RESET PROCEDURES .
scientia non olet · About LEMON Manuals