51 13 115 Removing and installing/replacing cowl panel cover
WARNING: This page is about a different car, the 2005 BMW 645Ci and 2004 BMW 645Ci. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove both windshield wiper arms
- Remove lower microfilter housing section on left and right
Release clip on left/right.
Turn quick-release fasteners (2) approx. 90° counterclockwise.
NOTE:
The fastener is closed if the arrow tips point to each other.
Unscrew bolt (1).
Remove cowl panel cover towards top.
Installation:
Tighten down screw (1) to tightening torque, refer to 51 13 5AZ in BODY EQUIPMENT - TIGHTENING TORQUES - 645CI .
Check cover (3) for correct seating.
Tighten quick-release fasteners (2) from the middle.