51 14 010 Removing and installing/replacing rear BMW badge

WARNING: This page is about a different car, the 2005 BMW 645Ci and 2004 BMW 645Ci. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required

NOTE: For special tools, refer to BODY EQUIPMENT - SPECIAL TOOLS - 645CI (E63) .

00 9 322

NOTE: The rear BMW badge is secured with adhesive tape. The position of the badge is determined by two guide pins on the back. The BMW badge must be fitted at room temperature.

Carefully heat BMW badge with a hot air blower.

Use special tool 00 9 322 to remove.

Fig 1: Removing BMW Badge With Special Tool 00 9 322

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Adhesive tape and residue must be removed prior to fitting.