22 31 001 Replacing rubber mount for transmission mounting

WARNING: This page is about a different car, the 2010 BMW 650i, 2009 BMW 650i, 2008 BMW 650i, 2007 BMW 650i, and 2006 BMW 650i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove underbody protection
Remove complete Exhaust System . See EXHAUST SYSTEM - REPAIR .
If necessary, remove exhaust system bracket
Support transmission with hydraulic lifter.

If necessary, remove heat shield (1) on left and right.

Fig 1: Identifying Heat Shield

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: N53 only

Release cable from holders (1).

Remove cable from holders on heat shield.

NOTE: Illustration similar

Fig 2: Identifying Cable Holders

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and nuts (2) and remove transmission cross-member.

Remove transmission mount from transmission crossmember.

Tightening torque 23 71 2AZ/5AZ . See 23 71 TRANSMISSION MOUNTS .

NOTE: Illustration similar.

Fig 3: Identifying Transmission Crossmember Screws And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

(M47/N47)

Release screws and nut (1).

Remove cross member.

Tightening torque 23 71 2AZ/ 5AZ , see 23 71 TRANSMISSION MOUNTS .

NOTE: Illustration similar

Fig 4: Identifying Screws And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

(M47/N47)

Slacken nut (1).

Exchange rubber mount.

Tightening torque 23 71 5AZ , see 23 71 TRANSMISSION MOUNTS .

Fig 5: Identifying Nut

Courtesy of BMW OF NORTH AMERICA, INC.

M57/M57T2 only

Unfasten screws (1) and nuts (2).

Remove transmission cross-member.

Remove rubber mount from transmission cross-member.

Tightening torque 22 32 3AZ/ 4AZ , see 22 32 TRANSMISSION MOUNTS .

Fig 6: Identifying Transmission Cross-Member Screws And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.