22 32 001 Replacing rubber mount for transmission mounting

WARNING: This page is about a different car, the 2010 BMW 650i, 2009 BMW 650i, 2008 BMW 650i, 2007 BMW 650i, and 2006 BMW 650i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove rear underbody protection
Remove complete exhaust system . See EXHAUST SYSTEM - REPAIR .
Remove exhaust system bracket (M47/N47)
Support transmission with lifter.

If necessary, remove heat shield (1) on left and right.

Fig 1: Identifying Heat Shield

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: N53 only

Release cable from holders (1).

Remove cable from holders on heat shield.

NOTE: Illustration similar

Fig 2: Identifying Cable Holders

Courtesy of BMW OF NORTH AMERICA, INC.

M57/M57T2 only

Release screws (1) and nut (2) and remove transmission cross-member.

Remove rubber mount from transmission cross-member.

Tightening torque 22 32 3AZ/4AZ . See 22 32 TRANSMISSION MOUNTS .

Fig 3: Identifying Transmission Cross-Member Screws And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

M54/N52/N52K/N53/N62/N54 only:

Release screws (1) and nut (2) and remove transmission cross-member.

Remove rubber mount from transmission cross-member.

Tightening torque 22 32 3AZ/4AZ . See 22 32 TRANSMISSION MOUNTS .

NOTE: On N62TU from 03/07, remove grounding strap from transmission support block.

NOTE: Illustration similar.

Fig 4: Identifying Transmission Crossmember Screws And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

(M47/N47)

Release screws and nut (1).

Remove cross member.

Tightening torque 22 32 3AZ/4AZ , see 22 32 TRANSMISSION MOUNTS .

Fig 5: Identifying Screws And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

(M47/N47)

Slacken nut (1).

Exchange rubber mount.

Tightening torque 22 32 3AZ , see 22 32 TRANSMISSION MOUNTS .

Fig 6: Identifying Nut

Courtesy of BMW OF NORTH AMERICA, INC.