64 11 875 Removing and installing/replacing servodrive for defrosting flap
WARNING: This page is about a different car, the 2010 BMW 535xi, 2009 BMW 535xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- REMOVE TRIM PANEL FOR PEDAL ASSEMBLY .
- REMOVE air distributor in footwell and heating duct in rear compartment on left.
Press lock (1) and pull out servodrive for defrosting flap (2) in direction of arrow.
Unfasten plug connection (3) and disconnect.
Installation note:
Follow repair instruction "INSTALLING SERVODRIVE ".
Servodrive for defrosting flap (2) must snap audibly into place.