54 13 105 Removing and installing/replacing rear water channel

WARNING: This page is about a different car, the 2010 BMW 535xi, 2009 BMW 535xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove complete GLASS SLIDE/TILT SUNROOF
Remove GLASS SLIDE/TILT SUNROOF LID AT REAR

Unlock tab (2) and remove drip molding (1) towards top.

NOTE: 2 springs are loosely connected to guide for drip molding.

Installation:

Make sure springs are reinstalled on drip molding carriers.

Fig 1: Removing Drip Molding Towards Top

Courtesy of BMW OF NORTH AMERICA, INC.

Removing drip molding carrier:

NOTE: Drip molding carrier cannot be removed without incurring damage.

Break out tabs with a screwdriver and lever out carrier.

Installation:

Replace drip molding carrier and hook into place.

Fig 2: Locating Tabs

Courtesy of BMW OF NORTH AMERICA, INC.