11 31 Camshaft
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
CAMSHAFT - TIGHTENING TORQUES SPECIFICATION
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Upper and lower bearing strip of camshaft (steel screw 10.9) | N54 | M7 x 70 | Insert screws dry | |
| Jointing torque | 8 Nm | |||
| Torque angle | 60° | |||
| 2AZ Chain drive module to cylinder head | N54 | M6 x 35 | 8.5 Nm | |
| 3AZ Guide rail to crankcase | N54 | M8 | 20 Nm | |
| 4AZ Guide rail to cylinder head | N54 | M7 | 14 Nm | |
| 5AZ Chain tensioner to cylinder head | N54 | M22 x 1.5 | Replace sealing ring | 55 Nm |
| 6AZ Screw plug in cylinder head | N54 | M18 x 1.5 | 25 Nm | |