52 24 311 Removing and installing/replacing lock for left or right rear seat backrest

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Perform emergency actuation for rear seat backrest (1).

Release screws (2).

Tightening torque: 52 24 08AZ .

Fig 1: Identifying Rear Seat Backrest And Screws

G05504377

Courtesy of BMW OF NORTH AMERICA, INC.

Remove rear seat backrest and set down forwards.

Remove lock (1) completely from installation opening.

Fig 2: Removing Lock

G05504378

Courtesy of BMW OF NORTH AMERICA, INC.

Display bridge (1) can be pressed out of lock during emergency actuation.

Remove display bridge (1) from lock.

Display bridge (1) does not have to be reinstalled.

Fig 3: Identifying Bridge

G05504379

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide guide lug (1) of lock into opening (2).

Fig 4: Sliding Guide Lug Of Lock

G05504380

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting lock:

Slacken screws
Firmly push engaged rear seat backrest back
Tighten down screws

IMPORTANT: Check backrest lock without fail.