11 53 000 Removing and installing/replacing coolant thermostat

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Risk of scalding!

Only perform these tasks on an engine that has cooled down.

Danger of injury!

Risk of skidding due to coolant on the floor.

Recycling

Catch and dispose of drained coolant in a suitable collecting vessel.

Observe country-specific waste disposal regulations.

IMPORTANT: Read and comply with GENERAL NOTES .

Protect plug connections against coolant and dirt contamination.

Cover plug connections with suitable materials.

Necessary preliminary work:

NOTE: Illustration shows coolant thermostat removed.

Disconnect coolant hoses (arrows) on the thermostat (1) with clamping tongs.

Fig 1: Locating Thermostat Coolant Hoses

Courtesy of BMW OF NORTH AMERICA, INC.

Release hose clamp (1) and detach coolant hose.

Release hose clamp (2) and detach coolant hose.

Unlock and detach coolant hose (3).

Unlock and detach coolant hose (4).

Disconnect plug connection (5).

Release screws (6).

Tightening torque: 8 Nm

Remove coolant thermostat (7).

Fig 2: Identifying Hose Clamp, Coolant Hose, Plug Connection And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Illustration shows coolant thermostat removed.

Assemble engine.

FILL the cooling system.

Observe CAPACITIES .

Installation note:

Check coolant hoses for cracks and damage.

Renew coolant hoses as required.

Recommendation:

On vehicles older than five years, renew coolant hoses.

Check function of cooling system.