52 24 311 Removing and installing/replacing lock for left or right rear seat backrest

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Perform emergency actuation for rear seat backrest (1).

Release screws (2).

Tightening torque: 52 24 08AZ . See 24 REAR SEAT, NORMAL .

Fig 1: Identifying Rear Seat Backrest With Screws

G04727319

Courtesy of BMW OF NORTH AMERICA, INC.

Remove rear seat backrest and set down forwards.

Remove lock (1) completely from installation opening.

Fig 2: Removing Lock

G04727320

Courtesy of BMW OF NORTH AMERICA, INC.

Display bridge (1) can be pressed out of lock during emergency actuation.

Remove display bridge (1) from lock.

Display bridge (1) does not have to be reinstalled.

Fig 3: Identifying Bridge

G04727321

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide guide lug (1) of lock into opening (2).

Fig 4: Sliding Guide Lug Of Lock Into Opening

G04727322

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting lock:

Slacken screws
Firmly push engaged rear seat backrest back
Tighten down screws

IMPORTANT: Check backrest lock without fail.