52 17 205 Removing and installing/replacing both rear panels on left or right front seat backrest (long version)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Rear panel upper section:

Reach between rear panel and backrest cover and unclip rear panel upper section.
Remove rear panel towards top.

Installation:

Engage rear panel correctly in guide.

Retainers must not be damaged and must be preinstalled.

Fig 1: Removing Rear Panel Towards Top

G04742877

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) and disconnect.

Detach wiring harness retainers from rear panel.

Fig 2: Unlock Plug Connections (1) And Disconnect

G04742878

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement only:

Release screws (1).

Remove monitor (2).

Unlock trim (3) with button and remove.

Fig 3: Identifying Screws On Monitor

G05478252

Courtesy of BMW OF NORTH AMERICA, INC.

Rear panel trim lower section:

Reach between rear panel and backrest cover and unclip rear panel lower section.

Installation:

Retainers must not be damaged and must be preinstalled.

Fig 4: Identifying Rear Panel Trim Lower Section

G04742880

Courtesy of BMW OF NORTH AMERICA, INC.

Only when replacing on passenger side:

Unlock seat adjustment switch (1) and remove.

Fig 5: Identifying Seat Adjustment Switch

G04742881

Courtesy of BMW OF NORTH AMERICA, INC.