51 43 201 Removing and installing/replacing panel for roof pillar at front (A-pillar), left or right

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Follow safety instructions for working on cars with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Detach mucket (1) in area of panel (2).

Unclip protective cap (3) and remove.

Fig 1: Removing Protective Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque 51 43 2AZ . See 43 SIDE COVERING WITH ARMRESTS .

Unclip panel (2) at fastening point (3).

Feed out panel (2) from instrument panel (4) and remove.

Fig 2: Unclipping Panel At Fastening Point

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clip (1) remaining in bore.

If necessary, replace faulty clip (1).

Make sure guide (3) of panel (2) is correctly seated in associated mounting.

Position panel (2) preinstalled with clip (1) on associated bore and clip into place.

Fig 3: Identifying Panel, Clip And Guide

Courtesy of BMW OF NORTH AMERICA, INC.