51 12 810 Removing and installing / replacing deformation element on bumper carrier on left or right

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove CARRIER FOR REAR BUMPER TRIM

Release screws (1).

Remove locator (2) straight towards rear.

Tightening torque 51 12 3AZ . See 12 REAR BUMPER .

Fig 1: Identifying Screws And Locator

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Foam seal (1) on locator (2) must not be damaged.

Fig 2: Identifying Foam Seal On Locator

Courtesy of BMW OF NORTH AMERICA, INC.