51 12 156 Removing and installing rear bumper trim
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove luggage compartment trim on left/right. See 51 47 210 Removing and installing/replacing trunk trim panel on left side panel or 51 47 220 Removing and installing/replacing trunk trim panel on right side panel .
Release screws (1) from wheel arch cover (2) on left/right.
Release expansion rivet on left/right.
Pull bumper trim (4) out of mounting (3).
Installation:
Make sure bumper trim (4) is correctly positioned in relation to mounting (3).
Not M5
Release expansion rivets on bottom middle guide.
Release bumper trim (2) from catches (1).
Release screws (1) with sealing washers on left/right.
- 2 Tail light
- 3 Trim, rear apron
Installation:
Replace screws (1) with sealing washers.
Tightening torque 51 12 8AZ . See 12 REAR BUMPER .
Unclip bumper trim (1) to side panel (1) on left/right outwards.
Remove bumper trim (1) in direction of arrow towards rear with aid of a 2nd person.
If necessary, disconnect plug connection (wiring harness) of ultrasonic transducers.