51 46 006 Removing and installing/replacing trim for rear parcel shelf

Special tools required: 

• 00 9 317  . See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .

Necessary preliminary tasks: 

• Remove panel for roof pillar at front left/right  

Version without through-loading system: 

• Remove backrest for rear seat 52 24 010 REMOVING AND INSTALLING/REPLACING BACKREST FOR REAR SEAT (BASIC)

Version with through-loading system: 

• Fold back backrest completely
• Remove left/right side section  on rear seat backrest. See 52 26 008 REMOVING AND INSTALLING/REPLACING LEFT/RIGHT SIDES OF BACKREST ON REAR SEAT BACKREST (THROUGH-LOADING) .

Version with rear window roller blind only: 

Release screws in luggage compartment.

Installation: 

Tightening torque 51 46 3AZ  . See 46 PARCEL SHELF TRIM .

Fig 1: Identifying Luggage Compartment Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Version with rear window roller blind only: 

Disconnect plug connection (1).

Fig 2: Locating Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Release center seatbelt finisher strip (1) and feed out seatbelt strap (3).

Release expander rivet and pull rear parcel shelf (4) forwards.

Feed out left/right seatbelt strap (2) and disconnect speaker plug connection.

Fig 3: Releasing Center Seatbelt Finisher Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out rear parcel shelf (2) towards front.

Installation: 

Slide rear window shelf (2) correctly into ventilation grill guides (1).

Fig 4: Pulling Out Rear Parcel Shelf

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Following parts of center seatbelt finisher strip (3) must not be damaged or missing:

1. Guides
2. Retaining lugs
   Fig 5: Identifying Guides And Retaining Lugs

   Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, remove or replace rear window roller blind: 

Lever out protective cap (1) on left/right with special tool 00 9 317  .

Installation: 

Retaining lugs (2) of protective caps (1) must not be damaged or missing.

Fig 6: Removing Protective Cap With Special Tool 00 9 317

Courtesy of BMW OF NORTH AMERICA, INC.

Lift out shelf (3) over rear groove (1) of rear window roller blind.

Pull front guide (2) out of shelf (3) and remove roller sun blind towards bottom.

Fig 7: Pulling Front Guide Out Of Shelf

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement only: 

Remove left/right mid-range speaker (2).  See 65 13 188 REMOVING AND INSTALLING/REPLACING REAR MID-RANGE SPEAKER (IN REAR SHELF) .

If necessary, remove left/right tweeter  . See 65 13 195 REMOVING AND INSTALLING/REPLACING REAR TREBLE SPEAKER (IN REAR SHELF) .

Remove trims (1) for belt outlet on left/right from rear parcel shelf (3).

Fig 8: Identifying Belt Outlet Trims And Rear Parcel Shelf

Courtesy of BMW OF NORTH AMERICA, INC.