51 45 181 Removing and installing/replacing bottom right trim for instrument panel

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317 . See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .

NOTE: Move front passenger seat completely towards rear.

Drive bottom trim (1) towards rear with special tool 00 9 317 and remove.

Installation:

Make sure bottom trim (1) is correctly seated at retaining points (2).

Feed bottom trim (1) correctly into bottom right trim for instrument panel (3).

Fig 1: Removing Bottom Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

IMPORTANT: Carefully remove bottom right trim for instrument panel.

Move bottom right trim for instrument panel (2) slightly forwards and feed out towards rear.

Disconnect plug connection of footwell light (3).

Remove bottom right trim for instrument panel (2).

Fig 2: Removing Bottom Right Trim For Instrument Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Mounts (1) and guides (2) of bottom right trim for instrument panel (3) must not be damaged.

Make sure mounts (1) are correctly seated.

Replacement:

Remove footwell light (4). See 63 31 020 REMOVING AND INSTALLING/REPLACING FOOTWELL LIGHT .

Fig 3: Identifying Mounts And Guides Of Bottom Right Trim For Instrument Panel
Courtesy of BMW OF NORTH AMERICA, INC.