51 23 160 Removing and installing/replacing arrester hook on engine hood

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Raise bonnet/hood lid.

Release screws (1) and remove arrester hook (2).

Tightening torque 51 23 1AZ . See 23 HOOD LATCH, LOCKS .

Fig 1: Identifying Screws And Arrester Hook

Courtesy of BMW OF NORTH AMERICA, INC.