72 11 050 Removing And Installing/Replacing Front Belt Anchor Fitting Tensioner (Driver Seat Only)

WARNING: This page is about a different car, the 2008 BMW 550i, 2007 BMW 550i, and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Read and comply with SAFETY REGULATIONS for handling airbag modules and pyrotechnical belt tensioners.

Improper handling can lead to triggering of the pyrotechnical seat belt tensioner or side airbag, resulting in injuries.

Switch off ignition!

Necessary preliminary tasks:

Remove UPPER RAIL TRIM

Disconnect cable straps.

Installation:

Replace faulty cable straps.

Plug connection must not be under tension.

Unfasten plug connection (1) and disconnect.

Release screw (2).

Tightening torque 72 11 08AZ . See SEAT BELTS for specs.

Remove anchor fitting tensioner (3).

Installation:

Secure plug connection with felt strip against unlocking.

Fig 1: Identifying Plug Connection And Anchor Fitting Tensioner

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, detach felt.

Using screwdriver, press pin (1) into recess and release anchor fitting (2).

Installation:

Anchor fitting (2) is coded.

Fig 2: Pressing Pin Into Recess And Release Anchor Fitting

Courtesy of BMW OF NORTH AMERICA, INC.