51 43 150 Removing And Installing Or Replacing Trim For Left Or Right Door Pillar (Bottom)

Necessary preliminary tasks: 

• Remove front entrance cover strip  . See 51 47 000 REMOVING AND INSTALLING / REPLACING ENTRANCE COVER STRIP, FRONT (INSIDE) LEFT OR RIGHT .

Release screw (1).

Remove nozzle (2) in direction of arrow from trim (3).

Fig 1: Removing Nozzle And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 2: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Partially detach mucket in area of B-pillar panel.

Unclip panel (1) in direction of arrow from B-pillar.

If necessary, lever clips (2) out of grommets in B-pillar.

Fig 3: Detaching Mucket In Area Of B-Pillar Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

If necessary, replace defective grommets (1).

If necessary, release screws (3) and remove holder (2).

Fig 4: Identifying Screws And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Following parts of panel for door trim (5) must not be damaged or missing:

1. Clips
2. Sound insulation
3. Air duct
4. Plate
   Fig 5: Identifying Door Trim Panel Clips, Sound Insulation And Air Duct

   Courtesy of BMW OF NORTH AMERICA, INC.