54 10 004 Adjusting glass tilt sunroof lid
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove gaiter on left and right.
- Close glass tilt sunroof lid completely.
- Check glass tilt sunroof for correct adjustment.
Gap adjustment only:
- Remove roofliner. See 51 44 005 REMOVING AND INSTALLING/REPLACING ROOFLINER (VERSION WITHOUT GLASS TILT SUNROOF) .
If the glass tilt sunroof is outside the adjustment tolerances, adjust as follows:
Height adjustment:
Carry out the following step on one side first and then the other (left, right or vice versa):
- Slacken Torx screws (1) on left/right so that sunroof lid (2) can still just be adjusted.
- Move sunroof lid as required.
- Make sure all screws are tightened down.
- Tightening torque, see 54 10 5AZ in 10 GLASS TILT SUNROOF .
- Repeat work steps on the other side.
Checking height:
Check height of glass lid (1) in relation to body (2) with special tool 00 9 315. Press glass lid (1) at front and rear towards top or bottom until ideal position is reached.
Height:
- Front - glass lid flush to 2 mm lower.
- Rear - glass lid flush to 2 mm higher.
Check function and adjustment.
Gap adjustment:
- Slacken Torx screws (1) so that sunroof lid (2) can still just be adjusted.
- Move sunroof lid as required.
- Make sure all screws are tightened down.
- Tightening torque, see 54 10 5AZ in 10 GLASS TILT SUNROOF .