51 61 Reinforcement, body
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
REINFORCEMENT, BODY - TIGHTENING TORQUES SPECIFICATION
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Tension strut in engine compartment | E60 / E61 / E63 / E64 | M8 | Replace screws | |
| Screw connection again | 27 Nm | ||||
| New component / initial screw connection | 30.5 Nm | ||||
| 2AZ | Structural tension strut, front | E64 | M12 | Replace screws | |
| Jointing torque | 100 Nm | ||||
| Torque angle | 90 ° | ||||
| E64 | M6 | Replace screws | |||
| Jointing torque | 8 Nm | ||||
| 3AZ | Tension strut to rear axle | E60 / M5, E61 / M5, E63 / M6, E64 / M6 | M8 | M8 8.8 | 24 Nm |
| M8 10.9 | 30 Nm | ||||
| E61, E64 | M12 | Replace screws | |||
| Jointing torque | 100 Nm | ||||
| Torque angle | 90 ° | ||||
| E61, E64 | M8 | Nut | 19 Nm | ||
| 4AZ | Tension strut, rear axle, front | E61 / M5, E64 / M6 | M12 | Replace screws | |
| Jointing torque | 100 Nm | ||||
| Torque angle | 90 ° | ||||
| 5AZ | Tension strut, rear axle, rear | E61 / M5, E64 / M6 | M12 | Replace screws | |
| Jointing torque | 100 Nm | ||||
| Torque angle | 90 ° | ||||
| 6AZ | Cross strut/rear | E61, E64 | M10 | Nuts | 41 Nm |
| Screws | 59 Nm | ||||
| 7AZ | Connection carrier to body | E60, E61 | M8 | 24 Nm | |