24 00 043 Installing Replacement Transmission (GA6HP26Z/6HP32Z)
Drain automatic transmission fluid at oil drain plug.
Tightening torque: 24 11 6AZ . See TRANSMISSION HOUSING, TRANSMISSION OIL SUMP for specs.
After completion of work, program transmission control unit.
Recycling:
Catch and dispose of escaping transmission fluid.
Observe country-specific waste-disposal regulations
- Before installing replacement transmission, always flush TRANSMISSION FLUID COOLER TOGETHER WITH LINES .
- After completion of work, check TRANSMISSION FLUID LEVEL .
Replacement transmission is supplied filled with transmission fluid.
Use only the approved transmission fluid.
Failure to comply with this instruction will result in serious damage to the transmission.
Necessary preliminary tasks:
- Remove AUTOMATIC TRANSMISSION .
E65 only.
If necessary, remove transmission support block from transmission.
Mount transmission block on replacement transmission.
E60/E61 only:
Release screws.
Remove transmission support block (1) and exhaust system bracket (2).
Tightening torque 24 71 6AZ . See TRANSMISSION MOUNTS for specs.
E60/E61 from 03/07 only
Release bolts (1).
Remove engine support frame with exhaust system bracket.
Tightening torque 24 71 6AZ . See TRANSMISSION MOUNTS for specs.
Convert transportation lock (1).
Convert all cable holders.
Convert all seal plugs.
Convert protective cap on output shaft.
After removing transportation lock, secure torque converter against slipping out.
Transmission identification:
- on type plate