26 11 160 Replacing constant-velocity joint for propeller shaft

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

23 1 160
26 1 110
26 1 121
26 1 122
31 2 102
31 2 104

Necessary preliminary tasks:

Remove propeller shaft.

Lever sealing cap (1) with screwdriver (2) out of constant-velocity joint (3).

NOTE: Replace sealing cap (1) with seal.

Fig 1: Identifying Sealing Cap With Seal

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Installation sequence:

Constant-velocity joint
Seal
Sealing cap

Fig 2: Identifying Constant-Velocity Joint, Seal And Sealing Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Lift off retainer

Installation:

Replace circlip.

Fig 3: Locating Circlip

Courtesy of BMW OF NORTH AMERICA, INC.

Force cap off constant velocity joint.

Installation:

Insert sealing washer (1) into constant-velocity joint.

Fig 4: Inserting Sealing Washer Into Constant-Velocity Joint

Courtesy of BMW OF NORTH AMERICA, INC.

Detach constant-velocity joint (1) with special tool 26 1 110 and commercially available special tool (2).

Fig 5: Detaching Constant-Velocity Joint With Special Tool (26 1 110)

Courtesy of BMW OF NORTH AMERICA, INC.

Release clamp (1) and detach cap with gaiter.

Push on new cap with gaiter.

NOTE: Do not tighten down clamp (1) yet.

Fig 6: Pushing On Cap With Gaiter

Courtesy of BMW OF NORTH AMERICA, INC.

Mount constant-velocity joint with special tool 23 1 160 up to stop.

Align bores of constant velocity joint and cap to each other.

Tighten down clamp on gaiter.

NOTE: Keep toothing free of grease.
Inject new grease into constant velocity joint from rubber gaiter and flange sides.

Fig 7: Identifying Special Tool (23 1 160)

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Prepare special tools 31 2 102 and 31 2 104.

Fig 8: Identifying Special Tool (31 2 102) And (31 2 104)

Courtesy of BMW OF NORTH AMERICA, INC.

Press sealing cap with special tools 26 1 121, 26 1 122, 31 2 102 and 31 2 104 into constant-velocity joint (1).

NOTE: Align sealing cap and seal to bores of constant-velocity joint with screw.

Fig 9: Identifying Constant-Velocity Joint And Special Tool (26 1 22), (26 1 121), (31 2 104)

Courtesy of BMW OF NORTH AMERICA, INC.

Push cap (1) onto constant-velocity joint (2).

Fig 10: Pushing Cap Onto Constant-Velocity Joint

Courtesy of BMW OF NORTH AMERICA, INC.