26 11 051 Replacing flexible disk for propeller shaft
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove rear underbody protection.
- Remove complete exhaust system.
- Remove heat shields.
- Remove transmission cross-member.
- Remove propeller shaft at transmission and centre bearing.
NOTE:
To protect constant-velocity joint, tie back propeller shaft in area of centre bearing.
Release screws and remove flexible disk (1) from propeller shaft.
Tightening torque: 26 11 1AZ. See PROPELLER SHAFT - TIGHTENING TORQUES .
Installation:
Arrows (3) on circumference of flexible disk must point to flange arms (2).
Replace self-locking nuts.
Tighten down screw connection via nut only.
Installation:
Check centering element, replace centering element if damaged.
Grease centering mount.