67 62 000 Removing and installing/replacing flat motor for front left or right power window unit

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Release sound insulation on front door . See 51 48 060 REMOVING AND INSTALLING/REPLACING SOUND INSULATION IN FRONT DOOR, LEFT OR RIGHT .

Unfasten plug connection (1) and disconnect.

Release screws (2).

Detach flat motor for power window unit (3) in direction of arrow from power window unit (4) and remove.

Fig 1: Detaching Flat Motor

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

A normalization must be carried out in order to activate anti - trapping protection.

Operating sequence for normalization:

Open corresponding window completely.
Operate corresponding power window switch in "Close" position (second switch stage).
Once the upper end position has been reached, hold power window switch down for approx. 1 second more.

Normalization is thus completed.

NOTE: Carry out function check (one-touch function, anti-trapping protection and, if necessary, comfort function).