65 82 050 Removing and Installing (Replacing) On-Board Monitor

WARNING: This page is about a different car, the 2009 BMW 650i, 2008 BMW 650i, and 2007 BMW 650i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Read and comply with notes on protection against electrostatic damage (ESD protection). See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
Proceed with care so as to avoid damaging the on - board monitor and adjoining trims.

Release screws (1).

Fold out on-board monitor (2) in direction of arrow.

Fig 1: Identifying On-Board Monitor In Direction Of Arrow

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) and disconnect.

Installation:

Ensure correct cable routing.

Remove on-board monitor (2).

Fig 2: Identifying Plug Connections & On-Board Monitor

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out programming/coding using BMW scan tool.