65 24 030 Removing and Installing/Replacing a TV Amplifier

WARNING: This page is about a different car, the 2009 BMW 650i, 2008 BMW 650i, and 2007 BMW 650i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove rear right head restraint. See 52 24 390 REMOVING AND INSTALLING/REPLACING REAR HEAD RESTRAINTS
Remove panel for roof pillar at rear left. See 51 43 251 REMOVING AND INSTALLING/REPLACING TRIM PANEL FOR LEFT OR RIGHT REAR ROOF PILLAR (C-PILLAR)

Unfasten plug connection (1) and disconnect.

Release screw (2).

Remove TV amplifier (3) in direction of arrow.

NOTE: The second TV amplifier (4) is removed in the same way.

Fig 1: Remove TV Amplifier In Direction Of Arrow

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fit TV amplifier (1) so that screw (2) engages thread (3) and locating pin (4) engages bore (5).

Fig 2: Fitting TV Amplifier So Screw Engages Thread & Locating Pin Engages Bore

Courtesy of BMW OF NORTH AMERICA, INC.