65 12 072 Removing and Installing (Replacing) Amplifier (Top Hi-Fi System)

WARNING: This page is about a different car, the 2009 BMW 650i, 2008 BMW 650i, and 2007 BMW 650i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection). See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)

Necessary preliminary tasks:

Remove luggage compartment wheel arch trim on left. See 51 47 151 REMOVING AND INSTALLING/REPLACING LEFT LUGGAGE COMPARTMENT WHEEL ARCH TRIM

NOTE: Follow instructions for handling optical fibers. See 61 00... NOTES ON HANDLING OPTICAL FIBERS

Release screws (1) and remove holder (2).

Fig 1: Identifying Screws & Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) and disconnect.

Pull out retaining plates (2) in direction of arrow.

Installation:

Make retaining plates (2) are correctly seated.

Remove amplifier (3) from holder (4).

Fig 2: Identifying Retaining Plates In Direction Of Arrow

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out programming/coding using BMW scan tool.