63 13 150 Removing and installing/replacing complete front left turn signal lamp

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove front left wheel trim. See 51 71 040 REMOVING AND INSTALLING/REPLACING FRONT LEFT OR RIGHT WHEEL ARCH COVER .

Release screw (1) on turn signal lamp (2).

Fig 1: Identifying Turn Signal Lamp Screw

G04761741

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Release screws (2) on front side panel (3).

Installation:

Make sure front side panel reinforcement plate is correctly seated.

Tightening torque 41 35 1AZ . See BODY EQUIPMENT - TIGHTENING TORQUES .

Raise front side panel (3) slightly and remove front turn signal lamp (4) in direction of travel.

Fig 2: Identifying Front Side Panel Screws

G04761742

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure metal nuts (1) are correctly seated.

Replacement:

If necessary, release screw (2) and remove holder (3) from front turn signal lamp (4).

Fig 3: Removing Holder (3) From Front Turn Signal Lamp (4)

G04761743

Courtesy of BMW OF NORTH AMERICA, INC.