61 31 020 Removing and Installing/Replacing Ignition Starter Switch
WARNING: This page is about a different car, the 2010 BMW 650i, 2009 BMW 650i, 2008 BMW 650i, 2007 BMW 650i, and 2006 BMW 650i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Move ignition lock to key position 0 (stop)
- Remove lower section of steering column trim . See 32 31 020 REMOVING AND INSTALLING / REPLACING LOWER SECTION OF STEERING COLUMN TRIM
IMPORTANT:
Before removing ignition starter switch (1), secure inner shaft against turning:
Insert a M2.5*8 screw in bore (2).
Installation:
Remove screw in bore (2).
Release screws (1), tightening torque 61 31 1AZ. See 61 31 SWITCH
Installation:
Secure screws (1) with sealing paint.
IMPORTANT:
Carefully unlock and disconnect associated plug connection for ribbon cable.
Replace the ribbon cable if damaged.
The ribbon cable leads to the control unit for the Car Access System . See 61 35 015 REMOVING AND INSTALLING (REPLACING) CONTROL UNIT FOR CAR ACCESS SYSTEM
Remove ignition starter switch (2).