72 12 010 Removing and installing/replacing airbag module on left or right front door
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Read and comply with Safety regulations
for handling airbag modules and pyrotechnical belt tensioners.
Incorrect handling can activate airbag and cause injury.
Front and rear airbag modules must not be mixed up.
Incorrect handling can activate airbag and cause injury.
Front and rear airbag modules must not be mixed up.
Necessary preliminary tasks:
- Disconnect battery negative lead . See 61 00 ... BATTERY .
- Remove front door trim . See 41 FRONT DOOR TRIM PANEL .
Unfasten screws.
Carefully remove airbag module.
Installation:
Before installing airbag module, remove all foreign bodies (screws, etc.) from installation recess.
Replace screws.
Tightening torque 72 12 01AZ.