72 11 100 Removing and installing/replacing rear left or right seat belt (complete)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove backrest for rear seat . See SEATS - REPAIR .

NOTE: Illustration shows removal of left side.
The right side is removed in the same way as the left side.

NOTE: Before removing reversing clip, mark position to ensure correct alignment when installing.

Release screw (1).

Tightening torque 72 11 24AZ.

Remove reversing clip (2).

Fig 1: Identifying Automatic Reel And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) on automatic reel (2).

Tightening torque 72 11 20AZ.

Remove automatic reel (2) in direction of arrow.

Installation:

Coding (3) of automatic reel must be seated in opening (4) of body.

Fig 2: Remove Automatic Reel

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (2).

Tightening torque 72 11 22AZ.

Remove seat belt (1).

Installation:

Secure fitting of seat belt (1) by means of stop (3) in guide.

NOTE: The work step for "Removing and installing/replacing left or right seat belt" ends here.

Fig 3: Identifying Seat Belt And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Removing and installing/replacing rear left or right lower strap (belt buckle).

Necessary preliminary tasks:

Remove rear seat . See SEATS - REPAIR .

(2) Seat belt buckle, left
(3) Seat belt buckle, right

Release screw (1) on left and right.

Tightening torque 72 11 23AZ.

Remove relevant seat belt buckle.

Fig 4: Identifying Seat Belt Buckle And Screw

Courtesy of BMW OF NORTH AMERICA, INC.