51 45 185 Removing and installing/replacing panel for pedals

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.

Release screws (1).

Unclip trim for pedal assembly (3) at retaining points (2).

Pull back panel for pedals (3) in direction of arrow.

Disconnect associated plug connections and remove trim for pedal assembly (3).

Fig 1: Uncliping Trim For Pedal Assembly

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Disconnecting the plug connection for the hands-free system speaker results in fault memory entries in the telephone control unit (limitation in the emergency SOS call system).
After fitting, read out fault memory and if necessary delete entries.

Installation:

Guides (1) and clips (2) of trim for pedal assembly (3) must not be damaged.

Replacement:

Remove speaker of hands-free system (4).
Remove footwell light (5).

Fig 2: Identifying Pedal Assembly, Guide And Clips
Courtesy of BMW OF NORTH AMERICA, INC.