5123... Removing/installing ball sockets with clip
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Never lift off ball socket with engaged retainer.
Disassembly/assembly:
- Push on retainer in direction of groove with screwdriver.
- Lift off ball socket from ball pin.
- Slide retainer back.
- Fit ball socket on ball stud and snap into place with force.
Installation: Replace overstretched clips. Pack grease into two opposite positions in socket. The grease spreads after installation on the ball pin all round in the ball socket.