51 14 010 Removing and installing/replacing rear BMW badge
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 322
IMPORTANT:
The Instructions
on component cementing with double - sided adhesive tape serve as the basis for this repair instruction and must be observed without fail.
Heat BMW badge (1) with hot air blower and lever out with special tool 00 9 322 .
Installation:
Pull liner (protective film) off adhesive tape (1).
Position badge over guides (2 and 3) and press down firmly.