51 13 316 Removing and installing/replacing trim strip on roof gutter at left or right

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.

Detach mucket (1) in area of trim strip (2).

Fig 1: Identifying Mucket And Trim Strip

G04760868

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Make sure that body is not damaged.

Start at front, pull off trim strip (1) in direction of arrow from clips (2).

Installation:

To avoid leaks and noises, check all clips (2) for visible damage.

If necessary, replace faulty clips (2).

Fig 2: Pulling Off Trim Strip From Clips

G04752484

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure sealing strip (2) is correctly seated on trim strip (1).

Sealing strip (2) must not be damaged.

Fig 3: Identifying Trim Strip And Sealing Strip

G04760870

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT:

Carry trim strip by its middle section only (risk of damage)
Perform installation work with a second person helping
Prepositioning of trim strip
Ensure drip moulding runs parallel to side frame (risk of breakage)