51 11 156 Removing and installing front bumper trim

Raise hood lid.

Release screws (1) on bumper trim (2).

Fig 1: Identifying Bumper Trim And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out trim (1 and 2) in direction of arrow.

Installation: 

Make sure trims (2) are in correct installation position.

Fig 2: Removing Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Catches (1) on trim (2) must not be damaged.

Fig 3: Identifying Catches On Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Catches (1) and guide (2) on trim (3) must not be damaged.

Fig 4: Identifying Catches And Guide On Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on bumper trim (2).

Fig 5: Identifying Screws And Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on wheel arch trim (2).

Fig 6: Identifying Screws And Wheel Arch Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Pull bumper trim (1) in direction of arrow off side guide.

Fig 7: Pulling Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off bumper trim (1) towards front.

Version without headlight cleaning system: 

If necessary, disconnect plug connections on fog lamps (2) and/or Park Distance Control (3).

Remove bumper trim (1) towards front (with aid of a 2nd person).

Fig 8: Identifying Fog Lamps, Park Distance Control And Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Version with headlight cleaning system: 

Remove bumper trim towards front (with aid of a 2nd person).

Fig 9: Identifying Hose And Seal Pump Outlet

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Tabs (1) on bumper trim (2) must not be damaged.

Fig 10: Identifying Tabs On Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.