51 11 ... Installing/replacing license plate (without base)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.

Initial fitting:

Place drilling hole template (1) on bumper (2).

NOTE: Hole diameter = 2.5 mm.

Drill holes according to license plate.

Remove template (1).

Secure license plate with screws provided.

Tightening torque 51 11 7AZ . See BODY EQUIPMENT - TIGHTENING TORQUES .

Fit protective caps.

Fig 1: Identifying Hole Template And Bumper

Courtesy of BMW OF NORTH AMERICA, INC.

Repairing thread:

Drill out defective hole in bumper (2) to 9.5 mm diameter.

Insert blind rivet nut (1).

Secure license plate (3) with license plate screw (4).

Tightening torque 51 11 8AZ . See BODY EQUIPMENT - TIGHTENING TORQUES .

Fig 2: Identifying License Plate And Screws And Rivet Nut

Courtesy of BMW OF NORTH AMERICA, INC.