37 14 610 Removing and installing / replacing transversal-acceleration sensor
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection).
See 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
.
IMPORTANT:
Do not kink floor panelling under any circumstances!
Necessary preliminary tasks:
- Remove right front seat . See SEATS - REPAIR .
- Lift floor panelling and fold back to one side
Release screws (1).
Tightening torque 37 14 23AZ. See INTEGRATED SUSPENSION SYSTEMS - TIGHTENING TORQUES -- 650I .
Disconnect plug connection.
After installation:
- If necessary, carry out initial Dynamic Drive operation . See 37 10 001 Initial Operation With Test Run Of Dynamic Drive .