36 13 Subsequent installation of wheel-bolt lock

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.

Loosen wheel bolts.

Raise car so that wheel can be turned freely.

Release wheel studs to such an extent that the wheel can move freely on the wheel hub.

Turn wheel so that valve is face down.

Remove top wheel stud and insert wheel stud lock.

Fig 1: Locating Wheel Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Possible play in wheel center and wheel weight could cause imbalance.

This imbalance is reduced to a minimum by installing the somewhat heavier wheel-bolt lock in the top wheel-bolt position.

In this position - wheel stud lock at top, valve at bottom - tighten wheel studs hand-tight in diagonal sequence.

Lower car and tighten wheel bolts crosswise.

Tightening torque 36 10 1AZ . See WHEEL AND TIRES - TIGHTENING TORQUES .

If this sequence of fitting the wheel stud lock is followed by a customer complaint about wheel imbalance, it will be necessary to finish-balance the wheels.

Fig 2: Tightening Wheel Bolts With Torque Wrench

Courtesy of BMW OF NORTH AMERICA, INC.