34 52 525 Replacing One Front Pulse Generator
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection)
. See 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
NOTE:
Read and comply with General Information . See 34 00 ... GENERAL INFORMATION
Observe safety instructions on raising the vehicle . See 00 .. ... LIFTING VEHICLE WITH A LIFTING PLATFORM
Open plug housing (1), pull plug connection (2) out of bracket and disconnect.
Pull cable with rubber grommet out of bracket on spring strut.
Installation:
Ensure proper locking of plug connector and proper seating of rubber grommets.
Release hexagon socket head cap screw (1) and pull wheel speed sensor out of bore.
Installation:
Tightening torque 31 51 6AZ .
Clean bore hole for pulse generator and grease with Staburags NBU 12/K lubricating grease (refer to BRAKES - OPERATING FLUIDS ).