34 32 861 Replacing All Brake Pipes
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 34 5 100
NOTE:
The brake lines are only supplied in the straight version and correct length with connecting nipple.
Read and comply with General Information . See 34 00 ... GENERAL INFORMATION
After completing work, bleed brake system . See 34 00 050 BLEEDING BRAKE SYSTEM WITH DSC
Observe safety instructions on raising the vehicle . See 00 .. ... LIFTING VEHICLE WITH A LIFTING PLATFORM
New brake lines are bent into shape with bending tool 34 5 100 . See 34 5 100 BENDING FIXTURE
Removed brake pipes can be used as templates for bending.
IMPORTANT:
- Protective coating of brake line must not be damaged during bending.
- Do not kink or bend back brake lines.
- Watch distances to rigid and movable vehicle parts. Brake lines may not make contact or rub.
- Tighten down brake line couplings with torque wrench.
Installation:
Tightening torque 34 32 1AZ . See 34 32 BRAKE LINES