34 00 050 Bleeding Brake System With DSC: Notes
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove lower section of microfilter housing . See 64 31 061 REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT MICROFILTER HOUSING LOWER SECTION
- Read and comply with General Information . See 34 00 ... GENERAL INFORMATION
Observe the filling and bleeding instructions when replacing or repairing:
- Brake master cylinder
- Hydraulic unit
- Components and connecting lines which are fitted between these assemblies.
Connect bleeder unit with max. 2 bar filling pressure.
A second person is needed to help carry out this work.
- Connect BMW Diagnosis and Information System (DIS).
- Select path: Service functions - Chassis/Suspension - Slip control systems - Bleeding procedure.
- Connect bleeder unit to expansion tank and switch on.
IMPORTANT:
Check relevant Operating Instructions for each device.
Charging pressure should not exceed 2 bar.