33 32 051 Removing and installing/replacing left or right push rod/integral link
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If the integral link is detached from the wheel carrier or swinging arm, it is necessary after reinstallation to carry out a wheel/chassis alignment check.
Necessary preliminary tasks:
- Remove rear wheel .
- E61: Deactivate and empty air spring system
- Remove output shaft from rear differential
Support wheel carrier with workshop jack.
Release nut (1) and remove screw.
Release screw (2), press swinging arm downward and remove integral link (3).
Installation:
Replace self-locking nut.
First install swinging arm hand-tight, then tighten down screw (2).
Tighten screw/bolt connections in normal position .
Tightening torque (nut), see 33 32 22AZ in 32-CONTROL ARMS AND STRUTS .
Tightening torque (bolt), see 33 32 21AZ in 32-CONTROL ARMS AND STRUTS .
After installation:
- Check that output shaft is correctly seated in rear differential.
- E61: Activate and fill air suspension system
- Perform chassis alignment check